Terms and Conditions:

In order for us to proceed with the fitting service, there are a few pre-requisites that are required for us to conduct works.

Definitions:

For the purposes of these Terms and Conditions.

“Bare Rolling Shell” Means Solely a Vehicle shell with subframes, suspension, axles and wheels.

FULL ROLL CAGE FITTING REQUIREMENTS:

The body shell is to be stripped down to a bare rolling shell. This includes but is not limited to the removal of the following items:

Windscreen

Rear quarter windows

All interior trim and carpets

Airbags

Wiring loom within the cabin

Pedals

Fuel Tank + Lines

All Ancillaries (Heater boxes, Fuse boxes, Etc)

For roll cages extending to the front turrets additional items need removing:

Engine bay loom

Engine + Gearbox

Fuse boxes

Wipers + motors

The original Dash bar and Steering column may remain fitted to the vehicle.  

Any Items including but not limited to the list above, that SW Motorsports deems necessary to remove to complete works, will be charged a rate of £75 per hour. Any parts removed will be done so with the greatest intended care however any breakages will not be recompensed or replaced. Items removed will not be re-fitted unless explicitly quoted as part of our service.

For any works including but not limited to Full Roll Cage Fitting: SW Motorsports cannot be held responsible for damages to any parts that remain fitted to or remain within a bare rolling shell during works.